Ntp-Service Dscp; Ntp-Service Enable - HP MSR1003-8S Command Reference Manual

If you have configured the device to operate in broadcast server mode on an interface with the command,
do not add the interface to any aggregate group. To add the interface to an aggregate group, remove
the configuration of the command.
Examples
# Configure the device to operate in broadcast server mode and send NTP broadcast messages on
GigabitEthernet 2/0/1, using key 4 for encryption. Set the NTP version to 4.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ntp-service broadcast-server authentication-keyid 4
version 4
Related commands
ntp-service broadcast-client

ntp-service dscp

Use ntp-server dscp to set a DSCP value for IPv4 NTP packets.
Use undo ntp-server dscp to restore the default.
Syntax
ntp-service dscp dscp-value
undo ntp-service dscp
Default
The DSCP value for IPv4 NTP packets is 48.
Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Sets a DSCP value in the range of 0 to 63 for IPv4 NTP packets.
Usage guidelines
The DSCP value is included in the ToS field of an IPv4 packet to identify the packet priority.
Examples
# Set the DSCP value for IPv4 NTP packets to 30.
<Sysname> system-view
[Sysname] ntp-service dscp 30

ntp-service enable

Use ntp-service enable to enable the NTP service.
Use undo ntp-service enable to disable the NTP service.
99