Source Ipv6 - HP MSR1003-8S Command Reference Manual

Syntax
source ip ip-address
undo source ip
Default
No source IP address is configured for probe packets.
Views
DHCP/DLSw/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
Path/UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the source IP address for probe packets.
Usage guidelines
If you configure both the source interface and source ip commands for an ICMP echo or UDP tracert
operation, the most recent configuration takes effect.
The specified source IP address must be the IP address of a local interface, and the local interface must
be up. Otherwise, no probe packets can be sent out.
Examples
# Specify 10.1.1.1 as the source IP address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
Related commands
source interface

source ipv6

Use source ipv6 to configure the source IPv6 address for probe packets.
Use undo source ipv6 to remove the configured source IPv6 address. The IPv6 address of the interface
that sends a probe packet is the source IPv6 address of the probe packet.
Syntax
source ipv6 ipv6-address
undo source ipv6
Default
No source IPv6 address is configured for probe packets.
68