Ipv6 Netstream Aggregation - HP MSR1003-8S Command Reference Manual

sampler sampler-name: Specifies a sampler by its name. The name is a case-insensitive string of 1 to 31
characters.
Examples
# Use sampler abc for outbound IPv6 NetStream sampling on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ipv6 netstream inbound
[Sysname-GigabitEthernet2/0/1] ipv6 netstream inbound sampler abc

ipv6 netstream aggregation

Use ipv6 netstream aggregation to set an IPv6 NetStream aggregation mode and to enter the IPv6
NetStream aggregation mode view.
Use undo ipv6 netstream aggregation to cancel an IPv6 NetStream aggregation mode and to remove
the configuration for the IPv6 NetStream aggregation mode.
Syntax
ipv6 netstream aggregation { as | bgp-nexthop | destination-prefix | prefix | protocol-port |
source-prefix }
undo ipv6 netstream aggregation { as | bgp-nexthop | destination-prefix | prefix | protocol-port |
source-prefix }
Views
System view
Predefined user roles
network-admin
Parameters
as: Specifies the AS aggregation by source AS number, destination AS number, input interface index,
and output interface index.
bgp-nexthop: Specifies the BGP nexthop aggregation by BGP next hop IPv6 address and output
interface index.
destination-prefix: Specifies the destination-prefix aggregation by destination AS number, destination
address mask length, destination prefix, and output interface index.
prefix: Specifies the source and destination prefix aggregation by the following criteria:
Source AS number.
•
• Destination AS number.
Source address mask length.
•
Destination address mask length.
•
Source prefix.
•
Destination prefix.
•
• Input interface index.
Output interface index.
•
399