Info-Center Loghost - HP MSR1003-8S Command Reference Manual

The output shows that a different log is generated during the suppression period.
%Jan 1 07:30:24:643 2000 Sysname ARP/6/DUPIFIP:
Duplicate address 172.16.0.1 on interface Vlan-interface100, sourced from 00e0-fc58-123d
%Jan 1 07:30:55:645 2000 Sysname ARP/6/DUPIFIP:
Duplicate address 172.16.0.1 on interface Vlan-interface100, sourced from 00e0-fc58-123d
This message repeated 4 times in last 30 seconds.
The output shows that the system starts another suppression period.

info-center loghost

Use info-center loghost to specify a log host and to configure output parameters.
Use undo info-center loghost to restore the default.
Syntax
info-center loghost [ vpn-instance vpn-instance-name ] { hostname | ipv4-address | ipv6 ipv6-address }
[ port port-number ] [ facility local-number ]
undo info-center loghost [ vpn-instance vpn-instance-name ] { hostname | ipv4-address | ipv6
ipv6-address }
Default
No log hosts are specified.
Views
System view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If the log host is on the public network, do not specify this option.
hostname: Specifies a log host by its name, a case-insensitive string of 1 to 253 characters. The host
name can contain letters, digits, and special characters including hyphen (-), underscore (_), and dot (.).
ipv4-address: Specifies a log host by its IPv4 address.
ipv6 ipv6-address: Specifies a log host by its IPv6 address.
port port-number: Specifies the port number of the log host, in the range of 1 to 65535. The default is 514.
It must be the same as the value configured on the log host. Otherwise, the log host cannot receive system
information.
facility local-number: Specifies a logging facility from local0 to local7 for the log host. The default value
is local7. Logging facilities are used to mark different logging sources, and query and filer logs.
Usage guidelines
The info-center loghost command takes effect only after information center is enabled with the
info-center enable command.
The device supports up to four log hosts.
Examples
# Output logs to the log host 1.1.1.1.
434