Cwmp Cpe Connect Interface - HP MSR1003-8S Command Reference Manual

Usage guidelines
You can configure only one username for authentication to the preferred ACS URL. If you use the
command multiple times, the final username configuration takes effect.
For a successful connection, make sure the CPE has the same username setting as the ACS.
Examples
# Configure the username used for authentication to the preferred ACS URL.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp acs username newname
Related commands
cwmp acs password

cwmp cpe connect interface

Use cwmp cpe connect interface to specify the CWMP connection interface.
Use undo cwmp cpe connect interface to restore the default.
Syntax
cwmp cpe connect interface interface-type interface-number
undo cwmp cpe connect interface
Default
No CWMP connection interface is specified. The CPE selects the CWMP connection interface
automatically.
Views
CWMP view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the type and number of the CWMP connection interface.
Usage guidelines
CWMP connection interface is the interface that the CPE uses to communicate with the ACS. To
establish a CWMP connection, the CPE sends the IP address of this interface in the Inform message, and
the ACS replies to this IP address.
Typically, the CPE selects the CWMP connection interface automatically.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address on
the device, you do not need to specify the CWMP connection interface.
If the CPE has multiple Layer 3 interfaces, specify the interface that connects to the ACS as the CWMP
connection interface. This manual setting prevents incorrect CWMP connection interface selection, which
might occur with automatic selection.
Examples
Specify GigabitEthernet 2/0/1 as the CWMP connection interface.
275