Poe Enable - HP MSR1003-8S Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
ac: Specifies the PD disconnection detection mode as ac.
dc: Specifies the PD disconnection detection mode as dc.
Usage guidelines
If you change the PD disconnection detection mode while the device is running, the connected PDs are
powered off.
Examples
# Set the PD disconnection detection mode to dc.
<Sysname> system-view
[Sysname] poe disconnect dc
Related commands
display poe pse

poe enable

Use poe enable to enable PoE on a PI.
Use undo poe enable to disable PoE on a PI.
Syntax
poe enable
undo poe enable
Default
PoE is disabled on a PI.
Views
PI view
PoE profile view
Predefined user roles
network-admin
Usage guidelines
If a PoE profile has been applied to a PI, remove the application before configuring the PI in PoE profile
view.
If a PI has been configured, remove the configuration before configuring the PI in PI view.
Examples
# Enable PoE on a PI in PI view.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
146