Netconf Ssh Server Port; Xml - HP MSR1003-8S Command Reference Manual

netconf ssh server port

Use netconf ssh server port to specify a port to listen for NETCONF-over-SSH connections.
Use undo netconf ssh server port to restore the default.
Syntax
netconf ssh server port port-number
undo netconf ssh server port
Default
Port 830 listens for NETCONF-over-SSH connections.
Views
System view
Predefined user roles
network-admin
Parameters
port-number: Specifies a port by its number in the range of 1 to 65535.
Usage guidelines
When assigning a listening port, make sure the specified port is not being used by other services. The
SSH service can share the same port with other services, but it might not operate correctly.
Examples
# Specify port 800 to listen for NETCONF-over-SSH connections.
<Sysname> system
[Sysname] netconf ssh server port 800

xml

Use xml to enter XML view.
Syntax
xml
Views
User view
Predefined user roles
network-admin
network-operator
Usage guidelines
In XML view, use NETCONF messages to configure the device or obtain data from the device. The
NETCONF operations you can perform depend on the user roles you have, as shown in
268
Table 57.