Reaction Checked-Element Packet-Loss - HP MSR1003-8S Command Reference Manual

upper-threshold: Specifies the upper limit in the range of 1 to 500.
lower-threshold: Specifies the lower limit in the range of 1 to 500. It must not be greater than the upper
limit.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
Usage guidelines
You cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use the
undo reaction command to delete the entry, and then configure a new one.
For the MOS threshold, the number is expressed in three digits representing ones, tenths, and hundredths.
For example, to express a MOS threshold of 1, enter 100.
Examples
# Create reaction entry 1 for monitoring the MOS value of the voice operation, and set the upper limit
to 2 and lower limit to 1. Before the NQA operation starts, the initial state of the reaction entry is invalid.
After the operation, the MOS value is checked against the threshold range. If it exceeds the upper limit,
the state of the reaction entry is set to over-threshold. If it is below the lower limit, the state is set to
below-threshold. Once the state of the reaction entry changes, a trap message is generated and sent to
the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type voice
[Sysname-nqa-admin-test-voice] reaction 1 checked-element mos threshold-value 200 100
action-type trap-only

reaction checked-element packet-loss

Use reaction checked-element packet-loss to configure a reaction entry for monitoring packet loss in UDP
jitter or voice operation.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element packet-loss threshold-type accumulate accumulate-occurrences
[ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entry for monitoring packet loss is configured.
Views
UDP jitter operation view, voice operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
58