Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 318

• (5) Starting a control when STC = 0 and T_  0
The control will start from the current time (T_) at STC = 1 using the start point (SV0) as the control start point.
Setting value (SV)
SV2
SV1
SV0
T1_
Starts from the current time (T_) at STC=1.
• (6) Starting a control when STC  0
The control will start from the current STC and T_ using the control start point (start point (current) (SV0C)) of the previous
control (AUT mode).
Setting value (SV)
SV2
SV1
SV0C
T1_
Starts from the current STC and T_.
• (7) After the second cycle at cyclic
The control will start using the last setting value (SVn) as the next control start point (start point (current) (SV0C)).
Setting value (SV)
SV2
SVn
SV0C
SV1
SV0
T1_
10 LOOP CONTROL OPERATION
316
10.25 Multi-Point Program Setter (M+P_PGS2_)
T2_
T2_
Starts from SVn, which is
the last setting value.
T2_
Time (T_)
Time (T_)
Time (T_)
Tn_
Last step