Changing The Step Bearing Of The Crankshaft - KTM 1190 RC8 EU 2008 Repair Manual

30/ENGINE - WORK ON INDIVIDUAL PARTS

Changing the step bearing of the crankshaft

20.10
–
Press in outer shaft seal ring
–
Insert water pump cover
200456-10
–
Mark the position of the bearing joint
200459-10
–
Pull out the step bearing shells
Bearing puller (15112017000) (
Insert for bearing puller (60029018000) (
200460-10
–
Center the new main bearing shells
Step bearing tool (60029046028) (
200461-10
–
Support the clutch cover directly under the step bearing. Press in the step bearing
shells using the special tool until they are flush.
Step bearing tool (60029046028) (
200462-10
fully, with the open side flush and facing outwards.

.

.

using the special tool.

p. 195)
p. 196)
using the special tool.

p. 197)
p. 197)
101