30/ENGINE - WORK ON INDIVIDUAL PARTS
Changing the conrod bearing
16.3
–
Press shaft seal ring
open side facing inward.
Info
The shaft seal rings must be flush on the outside.
–
Position special tool
Press plate (45229047050) (
–
Position the crankshaft in the press with the special tool.
–
Press the crank pin out of the upper crank web with a suitable push-out drift.
Info
Hold the lower crank web.
–
Take off the connecting rod, bearing, and stop disks.
300839-10
–
Press the crank pin out of the crank web.
300840-10
–
Press the new crank pin
Anchor plate (46229047002) (
300845-10
–
Mount stop disks
Info
Oil the bearing thoroughly.
300841-10
–
Position special tool
Pressing device, crankshaft, complete (50329047000) (
Anchor plate (46229047002) (
Bushing, crankshaft pressing device (45229008001) (
–
Insert the crank web with the connecting rod and bearing.
300842-10
of the countershaft from the outside to the inside with the
between the crank webs.
p. 143)
all the way in.
p. 144)
, bearing, and connecting rod
on the press.
p. 144)
.
p. 144)
p. 142)
77