Tell Last Error.vi; Tell Set Point Position.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.5.5

Tell last error.vi

This VI returns the currently memorized error:
 @: OK.
 A: Unknown message code or floating point axis number.
 B: Axis number not correct.
 C: Parameter missing or out of range.
 D: Command not allowed.
 E: Home sequence already started.
 F: SmartStage value unknown.
 G: Displacement out of limits.
 H: Command not allowed in NOT REFERENCED mode.
 I: Command not allowed in CONFIGURATION mode.
 J: Command not allowed in DISABLE mode.
 K: Command not allowed in READY mode.
 L: Command not allowed in HOMING mode.
 M: Command not allowed in MOVING mode.
 S: Communication Time Out.
 U: Error during EEPROM access.
Connector Panel
Controls and Indicators
Axis in
Axis out
Last error
2.5.6

Tell set point position.vi

This VI returns the set point position. This is the output of the motion pro- filer, this
position changes during the motion of the positioner.
Connector Panel
Controls and Indicators
Axis in
Axis out
Set point position (units)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
50