Set Negative Position Limit.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.3.19

Set negative position limit.vi

When controller is in CONFIGURATION state, this VI sets the negative soft- ware
limit value for the positioner. This is the negative software position limit that will be
used to check that the move commands do not exceed the mechanical system travel
range. This is the value that will be used as the setup value for the negative software
position limit.
When controller is in DISABLE or READY state, this command sets the neg- ative
software position limit to be used for the next moves. It must be lower or equal to set
point position.
Connector Panel
Controls and Indicators
Axis in
Negative software position limit (units)
Axis out
2.3.20 Get positive position limit.vi
This VI returns the programmed positive software position limit value for the
positioner.
Connector Panel
Controls and Indicators
Axis in
Axis out
Positive software position limit (units)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
40