Motion; Set Velocity Feed Forward.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
2.3.25

Set velocity feed forward.vi

When controller is in CONFIGURATION state, this VI sets the velocity feed forward
of the PID control loop. This is the value that will be used as the setup value for the
velocity feed forward.
When controller is in DISABLE state, this VI sets the velocity feed forward to use for
the closed loop.
Connector Panel
Controls and Indicators
Axis in
Velocity feed forward value (volts*seconds/unit)
Axis out
2.4

Motion

2.4.1 Home.vi
This VI starts the execution of the HOME search sequence as defined by the set home
type command.
Connector Panel
Controls and Indicators
Axis in
Axis out
Single-Axis Motion Controller/Driver for DC or Stepper Motor
43 EDH0209En2020 – 04/13