Get Velocity.vi; Set Stepper Motor Configuration (Micro-Step Factor).Vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
2.2.51

Set stepper motor configuration (micro-step factor).vi

Set stepper motor configuration. This VI allows set the micro-step per full step factor: 0
< micro-step factor ≤ 2000 (SMC command = FRM).
This VI must be only used with a SMC100PP controller.
Connector Panel
Controls and Indicators
Axis in
Micro-step factor 0 < micro-step factor ≤ 2000
Axis out
2.2.52

Get velocity.vi

This VI returns the programmed velocity value.
Connector Panel
Controls and Indicators
Axis in
Axis out
Velocity value (units/s)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
NOTE
27 EDH0209En2020 – 04/13