Set Parameters From Smartstage.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
2.2.47

Set parameters from SmartStage.vi

When the parameter is 3, the controller enables the SmartStage safety fea- ture, at each
power-up the controller will check if the connected smart stage is the same as the one
recorded in its flash memory.
When the parameter is 2, the controller reads parameters from the smart stage and saves
them in its flash memory.
When the parameter is 1, the controller disables the SmartStage safety fea- ture and will
not check anything at power-up, it will set the stage reference to UNKNOWN.
Connector Panel
Controls and Indicators
Axis in
Parameters from SmartStage:
1: no SmartStage feature.
2: read from SmartStage.
3: check SmartStage at power-up.
Axis out
2.2.48 Get stepper motor configuration (full step).vi
This VI returns the current motion distance per motor's full step (SMC command =
FRS?).
This VI must be only used with a SMC100PP controller.
Connector Panel
Controls and Indicators
Axis in
Axis out
Full step (units)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
NOTE
25 EDH0209En2020 – 04/13