Set Base Velocity.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
2.2.7

Set base velocity.vi

This VI sets the profiler generator base velocity.
0 ≤ base velocity ≤ value fixed by VA command, see "set velocity" VI (SMC
command = VB).
This VI must be only used with a SMC100PP controller.
Connector Panel
Controls and Indicators
Axis in
Base velocity (units)
Axis out
2.2.8 Get controller's axis number.vi
This VI returns the programmed controller's axis number.
Connector Panel
Controls and Indicators
Axis in
Axis out
Controller's axis number
Single-Axis Motion Controller/Driver for DC or Stepper Motor
NOTE
9 EDH0209En2020 – 04/13