Gpio; Tell Analog Input Value.vi; Tell Ttl Inputs Value.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.6

GPIO

2.6.1

Tell analog input value.vi

This VI returns the analog input value in volts. This is the ±10 volts input located on the
J1 connector. The converter is a ±7 bits analog to digital converter with ±0.15 volts of
maximum offset and 5% full scale linearity. The voltage resolution is 0.078125 volts.
Connector Panel
Controls and Indicators
Axis in
Axis out
Analog input value (volts)
2.6.2

Tell TTL inputs value.vi

This command sets the TTL input value. This decimal number represents the binary
word made of all inputs where bit 0 is input 1, bit 1 is input 2, etc...
The input is 1 when the corresponding pin of J1 connector is connected to a voltage >
2.4 volts and 0 when it is connected to a voltage < 0.8 volts.
Connector Panel
Controls and Indicators
Axis in
Axis out
TTL inputs value (decimal)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
52