Enter/Leave Configuration State.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.2.1

Enter/Leave Configuration state.vi

This Configuration VI has two states that it can be in: NOT REFERENCE state and
CONFIGURATION state. When the switch on the VI is in the ON position (True
state), the controller changes from NOT REFERENCE to CONFIGURATION state.
Once in this state, the configuration parameters can be changed.
When the switch is in the OFF position (False state), the controller changes from
CONFIGURATION to NOT REFERENCE state. The controller will check the
parameters, if they are acceptable, they will be saved in the flash mem- ory.
Connector Panel
Controls and Indicators
Axis in
enter configuration state (True)
Axis out
2.2.2 Get acceleration.vi
This VI returns the programmed acceleration value.
Connector Panel
Controls and Indicators
Axis in
Axis out
Acceleration (units/s
Single-Axis Motion Controller/Driver for DC or Stepper Motor
2
)
6