SMC100CC & SMC100PP
2.2.11
Set control loop state.vi
1 makes the controller to change the control loop from OPEN to CLOSED
state.
0 makes the controller to change the control loop from CLOSED to OPEN
state.
Connector Panel
Controls and Indicators
Axis in
Control loop state:
1: change to closed,
0: change to open,
Axis out
2.2.12
Get cut off frequency.vi
This VI returns the programmed low pass filter cut off frequency value for
Kd.
Connector Panel
Controls and Indicators
Axis in
Axis out
Cut off frequency value (Hertz)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
11
EDH0209En2020 – 04/13