Set Controller's Axis Number.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.2.9

Set controller's axis number.vi

This VI sets the controller's axis number. The controller will use this axis number only
when it will be configured in RS485 mode. In RS232C mode, the controller will only
respond to command related to axis 1. Only one controller can be configured with
RS232C communication.
Connector Panel
Controls and Indicators
Axis in
Controller's axis number
Axis out
2.2.10 Get control loop state.vi
This VI returns the control loop state:
0: the loop is open.
1: the loop is closed.
Connector Panel
Controls and Indicators
Axis in
Axis out
Control loop state:
1: closed.
0: open.
Single-Axis Motion Controller/Driver for DC or Stepper Motor
10