Set Stepper Motor Configuration (Full Step).Vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.2.49

Set stepper motor configuration (full step).vi

Set stepper motor configuration. This VI allows set the motion distance per motor's full
-6
step: 1E < full step < 1E
This VI must be only used with a SMC100PP controller.
Connector Panel
Controls and Indicators
Axis in
Full step (units) 1E
Axis out
2.2.50 Get stepper motor configuration (micro-step factor).vi
This VI returns the current micro-step per full step factor (SMC command = FRM?).
This VI must be only used with a SMC100PP controller.
Connector Panel
Controls and Indicators
Axis in
Axis out
Micro-step factor
Single-Axis Motion Controller/Driver for DC or Stepper Motor
12
(SMC command = FRS).
NOTE
-6
< full step < 1E
NOTE
26
12