Set Acceleration.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
2.3.3

Set acceleration.vi

When the controller is in Configuration state, this VI sets the maximum acceleration
value for the positioner. This is the maximum acceleration that will be applied to the
mechanical system. It is the value that will be used as the setup value for the
acceleration.
When the controller is in DISABLE or READY state, this VI sets the accelera- tion to
use for the next moves.
Connector Panel
Controls and Indicators
Axis in
Acceleration (units/s
Axis out
2.3.4 Get cut off frequency.vi
This VI returns the programmed low pass filter cut off frequency value for
Kd.
Connector Panel
Controls and Indicators
Axis in
Axis out
Cut off frequency value (Hertz)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
2
)
33 EDH0209En2020 – 04/13