Set Cut Off Frequency.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.2.13

Set cut off frequency.vi

When the controller is in CONFIGURATION state, this VI sets the low pass filter cut
off frequency value. That is the value that will be used as the setup value for the low
pass filter cut off frequency.
When controller is in DISABLE state, this VI sets the low pass filter cut off frequency
to be used for closed loop.
Connector Panel
Controls and Indicators
Axis in
Cut off frequency value (Hertz)
Axis out
2.2.14 Get driver voltage.vi
This VI returns the programmed driver voltage value.
Connector Panel
Controls and Indicators
Axis in
Axis out
Driver voltage value (Volts)
2.2.15 Set driver voltage.vi
This VI sets the maximum value of the voltage that is never to be exceeded when
driving the motor.
Connector Panel
Controls and Indicators
Axis in
Driver voltage value (Volts)
Axis out
Single-Axis Motion Controller/Driver for DC or Stepper Motor
12