Set Velocity.vi - Newport SMC100CC Manual

SMC100CC & SMC100PP
EDH0209En2020 – 04/13
2.3.23

Set velocity.vi

When controller is in CONFIGURATION state, this VI sets the maximum velocity
value for the positioner. This is the maximum velocity that will be applied to the
mechanical system. This is the value that will be used as the setup value for the
velocity.
When controller is in DISABLE or READY state, this command sets the velocity to be
used for the next moves.
Connector Panel
Controls and Indicators
Axis in
Velocity value (units/s)
Axis out
2.3.24 Get velocity feed forward.vi
This VI returns the programmed velocity feed forward value.
Connector Panel
Controls and Indicators
Axis in
Axis out
Velocity feed forward value (volts*seconds/unit)
Single-Axis Motion Controller/Driver for DC or Stepper Motor
42