Appendix: Firmware Version V2.2.X; Of - Set/Get Offset On Adc Inputs 1 To 4 - Newport CONEX-PSD User Manual

CONEX-PSD
5.0

Appendix: Firmware Version V2.2.x

EDH0315En1030 — 07/16
Not every command can be executed in all states of the CONEX-PSD and some
commands have different meaning in different states. It is therefore important to
understand the state diagram of the controller, see section
Ready Config.
GP
 
ID
 
IS
 
IX
 
IY
 
LF
 
OF
 
PS
 
PX
 
PY
 
PW
 
RA
 
RC
 
RS
 
RS##
 
SA
–

TB
 
TE
 
TS
 
VE
 
Changes configuration parameters. Those changes will be stored in the

controller's memory with the PW1 command and remain available after
switching off the controller.
Changes working parameters only. Those changes will get lost when switching

off the controller.
Accepted command.

–
Write command not accepted (will return an error).
Command Command passed without preceding controller number applies to all controllers.
Two-Axis Position & Power Sensing Device
Description
Get X, Y positions and laser power
Set/Get stage identifier
Set/Get Set/Get offset on ADC input Sum (Si sensor)
Not used (Ge sensor)
Set/Get offset on ADC input X (Si sensor)
Set/Get offsets on X position (Ge sensor)
Set/Get offset on ADC input Y (Si sensor)
Set/Get offsets on Y position. (Ge sensor)
Set/Get low pass filter frequency
Not used (Si sensor)
Set/Get offset on ADC inputs 1 to 4 (Ge sensor)
Set/Get gain on ADC input Summ (Si sensor)
Not used (Ge sensor)
Set/Get gain on ADC input X
Set/Get gain on X position (Ge sensor)
Set/Get gain on ADC input Y (Si sensor)
Set/Get gain on Y position. (Ge sensor)
Enter/Leave CONFIGURATION state
Get raw analog input values
Get corrected analog input values
Reset controller
Reset controller's address to 1
Set/Get controller's address
Get command error string
Get last command error
Get positioner error and controller state
Get controller revision information
12