Table of Contents
Advertisement
XPS-Q8 Controller
24.0
Appendix F: Motor Driver Cards
24.1
DC and Stepper Motor Driver XPS-DRV01
Motor +
Motor -
Ph1
Ph2
Ph3
Ph4
Common 3&4
Common 1&2
+ Travel limit
- Travel limit
Encoder A & /A
Figure 71:XPS-DRV01 Motor Driver Connectors.
This output must be connected to the positive lead of the DC
motor. The voltage seen at this pin is pulse-width modulated with
maximum amplitude of 48 V DC.
This output must be connected to the negative lead of the DC
motor. The voltage seen at this pin is pulse-width modulated with
maximum amplitude of 48 V DC.
This output must be connected to Winding A+ lead of a two-phase
stepper motor. The voltage seen at this pin is pulse-width
modulated with maximum amplitude of 48 V DC.
This output must be connected to Winding A- lead of a two-phase
stepper motor. The voltage seen at this pin is pulse-width
modulated with maximum amplitude of 48 V DC.
This output must be connected to Winding B+ lead of a two-phase
stepper motor. The voltage seen at this pin is pulse-width
modulated with maximum amplitude of 48 V DC.
This output must be connected to Winding B- lead of a two-phase
stepper motor. The voltage seen at this pin is pulse-width
modulated with maximum amplitude of 48 V DC.
This output must be connected to the center tab of Winding B of a
two-phase stepper motor. The voltage seen at this pin is pulse-
width modulated with maximum amplitude of 48 V DC.
This output must be connected to the center tab of Winding A of a
two-phase stepper motor. The voltage seen at this pin is pulse-
width modulated with maximum amplitude of 48 V DC.
This input is pulled-up to +5 V with a 2.2 kΩ resistor by the
controller and represents the stage positive direction hardware
travel limit.
This input is pulled-up to +5 V with a 2.2 kΩ resistor by the
controller and represents the stage negative direction hardware
travel limit.
These A and /A inputs are differential inputs. Signals are
compliant with RS422 electrical standard and are received with a
213
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Appendix
Advertisement
Table of Contents
