Part 3: Operation: Configuration Mode; Introduction; Table 3.1 Button Function In Configuration Mode - Newport i Series Operator's Manual

PART 3
OPERATION: Configuration Mode

3.1 Introduction

The instrument has two different modes of operation. The first, Run Mode, is
used to display Temperature and Relative Humidity. The other mode, Menu
Configuration Mode, is used to navigate through the menu options and
configure the controller. Part 3 of this manual will explain the Menu
Configuration Mode. For your instrument to operate properly, the user must
first "program" or configure the menu options.
Turning your Controller On for the First Time
The device becomes active as soon as it is connected to a power source. It
has no On or Off switch. The device at first momentarily shows the software
version number, followed by reset RST , and then proceeds to the Run Mode.
For first-time users: Refer to the QuickStart Manual for basic operation
and set-up instructions.
If you have the Serial Communications/Ethernet Option you can easily
configure the controller on your computer or on-line.

Table 3.1 Button Function in Configuration Mode

• To enter the Menu, the user must first press a button.
• Use this button to advance/navigate to the next menu item. The user can
a
navigate through all the top level menus by pressing a .
MENU
• While a parameter is being modified, press a to escape without saving the
parameter.
• Press the up b button to scroll through "flashing" selections. When a
numerical value is displayed press this key to increase value of a parameter
b
that is currently being modified.
(UP)
• Pressing the b button for approximately 3 seconds will speed up the rate at
which the set point value increments.
• In the Run Mode, pressing the b button changes display from RH readings
to Temperature readings.
• Press the down c button to go back to a previous Top Level Menu item.
• Press this button twice to reset the controller to the Run Mode.
• When a numerical value is flashing (except set point value) press c to scroll
c
digits from left to right allowing the user to select the desired digit to modify.
(DOWN)
• When a setpoint value is displayed press c to decrease value of a setpoint
that is currently being modified. Pressing the c button for approximately 3
seconds will speed up the rate at which the setpoint value is decremented.
• In the Run Mode, pressing the c button changes from RH readings to
Dewpoint readings.
• Press the enter d button to access the submenus from a Top Level Menu item.
d
• Press d to store a submenu selection or after entering a value — the display
ENTER
will flash a STRD message to confirm your selection.
• In the Run Mode, press d twice to enable Standby Mode with flashing STBY .
Reset: Except for Alarms, modifying any settings of the menu configuration
will reset the instrument prior to resuming Run Mode.
12