YASKAWA A1000 HHP Programming Manual page 16

1.1 A: Initialization
No.
L2-01 Momentary Power Loss Operation Selection
L8-03 Overheat Pre-Alarm Operation Selection
L8-38 Carrier Frequency Reduction
No.
b1-01 Frequency Reference Selection
b1-02 Run Command Selection
b1-03 Stopping Method Selection
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-02 Carrier Frequency Selection
d2-01 Frequency Reference Upper Limit
Setting 5: Compressor Application
No.
A1-02 Control Method Selection
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Duty Rating
E1-03 V/f Pattern Selection
L2-01 Momentary Power Loss Operation Selection
L3-04 Stall Prevention Selection during Deceleration
No.
b1-01 Frequency Reference Selection
b1-02 Run Command Selection
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
n A1-07: DriveWorksEZ Function Selection
Enables and disables the DriveWorksEZ program inside the drive.
DriveWorksEZ is a software package for customizing drive functionality or adding PLC functionality by the interconnection
and configuration of basic software function blocks. The drive performs user-created programs in 1 ms cycles.
Note: 1. If DriveWorksEZ has assigned functions to any of the multi-function output terminals, those functions will remain set to those terminals
even after disabling DriveWorksEZ.
2. For more information on DriveWorksEZ, contact a Yaskawa representative.
No.
A1-07
Setting 0: DWEZ disabled
Setting 1: DWEZ enabled
Setting 2: Digital input
If a digital input is programmed for DWEZ enable/disable (H1-oo = 9F), DWEZ will be enabled when the input is opened.
16
Parameter Name
Table 1.12 HVAC Fan: User Parameters (A2-01 to A2-16)
Parameter Name
Table 1.13 Compressor: Parameter Settings
Parameter Name
Table 1.14 Compressor: User Parameters (A2-01 to A2-16):
Parameter Name
Parameter Name
DriveWorksEZ Function Selection
YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
Default Setting
2: CPU Power Active - Drive will restart if power returns prior
to control power supply shut down.
4: Operation at lower speed
2: Enabled across entire frequency range.
No. Parameter Name
d2-02 Frequency Reference Lower Limit
E1-03 V/f Pattern Selection
E1-04 Max Output Frequency
E2-01 Motor Rated Current
H3-11 Terminal A2 Gain Setting
H3-12 Terminal A2 Input Bias
L2-01 Momentary Power Loss Operation Selection
o4-12 kWh Monitor Initial Value Selection
Default Setting
0: V/f Control
1: Reverse Prohibited
5.0 s
5.0 s
0: Heavy Duty
0F Hex
1: Enabled
1: Enabled
No. Parameter Name
E1-03 V/f Pattern Selection
E1-07 Mid Output Frequency
E1-08 Mid Output Frequency Voltage
E2-01 Motor Rated Current
–
Setting Range
0 to 2
–
Default
0