YASKAWA A1000 HHP Programming Manual page 127

n H6-06: Pulse Train Monitor Selection
Selects the monitor to output as a pulse train signal via terminal MP. Enter the three digits in Uo-oo to indicate which
monitor to output. Refer to U: Monitor Parameters on page 171
by H6-06 appear in the table below.
No.
H6-06
<1> Set "000" when the terminal is not used or when using the terminal in the through mode.
n H6-07: Pulse Train Monitor Scaling
Sets the output frequency at terminal MP when the specified monitor item is at 100%. Set H6-06 to 102 and H6-07 to 0 to
make the pulse train monitor output synchronous to the output frequency.
No.
H6-07
n H6-08: Pulse Train Input Minimum Frequency
Sets the minimum output frequency detected by the pulse train input. Increasing this setting reduces the time the drive needs
to react to changes in the input signal.
• The pulse input value becomes 0 when the pulse input frequency falls below this level.
• Enabled when H6-01 = 0, 1, or 2.
• When simple speed feedback in V/f Control is set as the function for terminal RP (H6-01 = 3), the minimum frequency
becomes the detection time for PG disconnect (F1-14).
No.
H6-08
YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
Name
Pulse Train Monitor Selection
Name
Pulse Train Monitor Scaling
Name
Pulse Train Input Minimum Frequency
for a complete list of monitors. Monitors that can be selected
Setting Range
<1>
000 , 031
105, 116, 501, 502,
801 to 809
Setting Range
0 to 32000 Hz
Setting Range
0.1 to 1000.0 Hz
1.7 H: Terminal Functions
Default
<1>
, 101, 102,
102
Default
1440 Hz
Default
0.5 Hz
1
127