Servicing The Motherboard Assembly (Fru) - Oracle Database Appliance X6-2-HA Manual

Install Boot Disk Backplane Cables
This section describes installing the boot disk backplane cables in Oracle Database Appliance
Version 1.
1. Reconnect the power cable and hard disk drive (HDD) cables.
a. Reconnect the power cable and HDD cables to the boot disk backplane [2].
b. Reconnect the power cable and HDD cables to the motherboard [1].
2. Return the server node to operation.
a. Install the server node top cover.
See
b. Install the server node into the system.
See
Power on the server node.
c.
See

Servicing the Motherboard Assembly (FRU)

Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
Each Oracle Database Appliance Version 1 server node has a motherboard assembly. The
service strategy for the motherboard is to remove the replaceable components from the server
node and then return the server node with the motherboard in place to Oracle for repair or
replacement.
The motherboard assembly is a FRU and can only be replaced by an Oracle-qualified service
technician.
Caution -
sensitive to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in
and Antistatic Prevention Measures" on page
202 Oracle Database Appliance Service Manual • June 2017
"Installing the Server Node Top Cover" on page
"Installing a Server Node Into the System Chassis" on page
"Powering On Oracle Database Appliance Version 1" on page
Information in this appendix does NOT apply to Oracle Database Appliance X3-
Equipment damage. These procedures require that you handle components that are
207.
208.
"Performing Electrostatic Discharge
112.
210.