Server Node Basic Input/Output System (BIOS)
b.
c.
Server Node Basic Input/Output System (BIOS)
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes the Oracle Database Appliance Version 1 BIOS utility. If you have
Oracle Database Appliance X6-2 series, go to
Utility" on page
X4-2, or Oracle Database Appliance X5-2, go to
BIOS Utility" on page
This section describes the Oracle Database Appliance Version 1 BIOS utility.
All settings are set to the optimal defaults at startup.
Caution -
software will do this for you. The only time you might need to configure BIOS settings would
be if requested to do so by Oracle Service.
The following topics are included:
"BIOS Booting and Setup" on page 213
■
"Configuring Support for TPM" on page 220
■
"Configuring SP LAN Settings" on page 226
■
"Configuring Option ROM Settings in BIOS" on page 228
■
"BIOS Setup Utility Hot Keys" on page 230
■
"Accessing the BIOS Setup Utility Menus" on page 230
■
"BIOS Setup Utility Screens" on page 233
■
212
Oracle Database Appliance Service Manual • June 2017
$
sp_ip_address
ssh username@
Where username is a user account name with Reset and Host Control (r) privileges
and sp_ip_address is the IP address of the server node service processor.
When prompted, enter the user account password.
Enter the command to power on the server node:
->
start /SYS
On the server node, the green Power/OK LED [2] blinks while the server node is
booting, and remains steady on when the server node is operational.
Information in this appendix does NOT apply to Oracle Database Appliance X3-
101. If you have Oracle Database Appliance X3-2, Oracle Database Appliance
103.
You should not configure system BIOS settings. Oracle Database Appliance patch
"Oracle Database Appliance X6-2 Series BIOS
"Oracle Database Appliance X3-2/X4-2/X5-2
Need help?
Do you have a question about the Database Appliance X6-2-HA and is the answer not in the manual?
Questions and answers