Oracle Database Appliance X6-2-HA Manual page 148

Remove PCIe Card From PCIe Riser
"Install PCIe Card in PCIe Riser" on page 150
■
"Remove Primary HBA PCIe Card From Motherboard" on page 153
■
"Install Primary HBA PCIe Card in Motherboard" on page 154
■
PCIe Card Configuration
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The Oracle Database Appliance Version 1 PCIe expansion system includes one standalone
low-profile slot on the motherboard and a PCIe riser with three slots. These are provisioned as
follows:
Motherboard slot – A low-profile, dual-port SAS-2 HBA used internally
■
PCIe slot 2 – Dual-port SAS-2 HBA used internally
■
PCIe slot 1 – Quad-port 1-Gb Ethernet NIC
■
PCIe slot 0 – Dual-port 10-Gb Ethernet NIC
■
Caution -
replacing.
Remove PCIe Card From PCIe Riser
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing a PCIe card from its riser in Oracle Database Appliance
Version 1.
1. Prepare the server node for service.
a. Attach an antistatic wrist strap.
See
Measures" on page
148 Oracle Database Appliance Service Manual • June 2017
Information in this appendix does NOT apply to Oracle Database Appliance X3-
If you replace a PCIe card, ensure the replacement is identical to the card you are
Information in this appendix does NOT apply to Oracle Database Appliance X3-
"Performing Electrostatic Discharge and Antistatic Prevention
112.