Powering On Oracle Database Appliance Version 1 - Oracle Database Appliance X6-2-HA Manual

Power On Oracle Database Appliance Version 1

Powering On Oracle Database Appliance Version 1

Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
To power on Oracle Database Appliance Version 1, follow this procedure.
Each server node is powered on separately.
Note -
initial configuration as described in "Connecting and Configuring Oracle ILOM" in the Oracle
Database Appliance Getting Started Guide.
Power On Oracle Database Appliance Version 1
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes powering on Oracle Database Appliance Version 1.
Ensure that the power cord (or cords) are connected to the power supplies on
1.
the rear of the server node that was serviced.
Once plugged in, the server node goes into the standby power state. The SP status LED on the
front panel of the server node lights green and goes from slow blink to steady on. The Power/
OK LED on the front panel of the server node lights green and goes to standby blink. It might
take about five minutes for the LED to reach standby blink after the power cord is inserted.
For the location of the SP status LED and Power/OK LED, see
Indicators" on page
Standby power state indicates that the server node's service processor is active, but the server
node host is powered off.
2. Power on a server node by performing one of the following:
If you powered off a single server node without shutting down the appliance, perform this step
only for that server node. If you shut down the appliance completely, then perform this step for
both server nodes.
210 Oracle Database Appliance Service Manual • June 2017
Information in this appendix does NOT apply to Oracle Database Appliance X3-
To use Oracle ILOM to power on a server node, ensure that you have performed its
Information in this appendix does NOT apply to Oracle Database Appliance X3-
37.
"Server Node Status