Oracle Database Appliance Version 1 Hot-Pluggable Components - Oracle Database Appliance X6-2-HA Manual

Oracle Database Appliance Version 1 Hot-Pluggable Components

Caution -
I/O module.
3. Open the lever in the new I/O module if it is not already open.
4. Slide the new I/O module into the disk shelf and close the locking lever.
5. Reconnect the cables.
Verify that the new I/O module is working correctly.
6.
After approximately 60 seconds, the power LED should be solid green and the Fault/Locate
■
LED should be off.
For each port that has a cable connected, all four activity LEDs should be solid green.
■
Oracle Database Appliance Version 1 Hot-Pluggable
Components
This section describes replacing hot-pluggable components for the Oracle Database Appliance
Version 1. If you have Oracle Database Appliance X6-2 series, go to
Appliance X6-2 Series Server Node Hot-Pluggable Components" on page
have Oracle Database Appliance X3-2, Oracle Database Appliance X4-2, or Oracle Database
Appliance X5-2, go to
Pluggable Components" on page 56
X6-2-HA Storage Shelf Hot-Pluggable Components" on page
74 Oracle Database Appliance Service Manual • June 2017
Equipment damage. Be careful not to damage the connector pins at the back of the
"Oracle Database Appliance X3-2/X4-2/X5-2 Server Node Hot-
or "Oracle Database Appliance X3-2/X4-2/X5-2 and
"Oracle Database
51. If you
57.