Oracle Database Appliance X6-2-HA Manual page 200

Remove Boot Disk Backplane Cables
See
b. Install the server node top cover.
See
c. Install the server node into the system.
See
d. Power on the server node.
See
Servicing the Boot Disk Backplane Cables (FRU)
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The Oracle Database Appliance Version 1 boot disk backplane cables connect the boot disk
backplane to the motherboard.
The boot disk backplane cables are FRUs and can only be replaced by an Oracle-qualified
service technician.
The following topics are covered in this section:
"Remove Boot Disk Backplane Cables" on page 200
■
"Install Boot Disk Backplane Cables" on page 201
■
Remove Boot Disk Backplane Cables
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the boot disk backplane cables from Oracle Database
Appliance Version 1.
1. Prepare the server node for service.
200 Oracle Database Appliance Service Manual • June 2017
"Install PCIe Riser in Server Nodes" on page
"Installing the Server Node Top Cover" on page
"Installing a Server Node Into the System Chassis" on page
"Powering On Oracle Database Appliance Version 1" on page
Information in this appendix does NOT apply to Oracle Database Appliance X3-
Information in this appendix does NOT apply to Oracle Database Appliance X3-
145.
207.
208.
210.