Servicing Server Node Cables - Oracle Database Appliance X6-2-HA Manual

Remove Fan Power Cables
b. Reconnect the power cords to the system and power on the system.
See

Servicing Server Node Cables

Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section includes information on servicing cables in Oracle Database Appliance Version 1.
The internal server node cables are FRUs and can only be replaced by an Oracle-qualified
service technician.
Caution -
sensitive to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in
and Antistatic Prevention Measures" on page
The following topics are covered in this section:
"Servicing the Fan Power Cables (FRU)" on page 190
■
"Servicing the PCIe Card Cables (FRU)" on page 192
■
"Servicing the SAS Expander Cable (FRU)" on page 197
■
"Servicing the Boot Disk Backplane Cables (FRU)" on page 200
■
Servicing the Fan Power Cables (FRU)
Each Oracle Database Appliance Version 1 server node has two fans and each fan has a separate
power cable.
Remove Fan Power Cables
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
190 Oracle Database Appliance Service Manual • June 2017
"Powering On Oracle Database Appliance Version 1" on page
Information in this appendix does NOT apply to Oracle Database Appliance X3-
Equipment damage. These procedures require that you handle components that are
Information in this appendix does NOT apply to Oracle Database Appliance X3-
"Performing Electrostatic Discharge
112.
210.