Log The Settings For The Extended Functions, Firmware V4.4 - Siemens SINAMICS G120 Function Manual

Appendix
A.2 Documentation for acceptance
A.2.4 Log the settings for the extended functions, firmware V4.4 ... V4.7
Drive = <pDO-NAME_v>
Table A- 8 Firmware version
Name
Control Unit firmware version
SI motion, version safe motion monitoring functions
SI Version safety functions integrated in the drive
Table A- 9 Monitoring cycle
Name
SI monitoring clock cycle
Table A- 10 Checksums
Name
SI Motion reference checksum SI parameters (processor 2)
SI module identifier, Control Unit
SI module identifier, Power Module
SI reference checksum SI parameters (processor 1)
SI Motion reference checksum SI parameters (processor 1)
SI reference checksum SI parameters (processor 2)
Table A- 11 Safety functions
Name
SI motion, enable safety-related functions
SI Motion function specification
SI Motion function configuration
SI Motion response during pulse suppression
SI motion, gearbox, motor/load, denominator
SI motion, gearbox, motor/load, numerator
SI Motion SLS limit values, limit value SLS1
SI Motion SLS limit values, limit value SLS2
SI Motion SLS limit values, limit value SLS3
SI Motion SLS limit values, limit value SLS4
SI Motion SLS speed setpoint limiting
SI motion, actual value comparison tolerance (crosswise)
314
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Number Value
r18 <r18_v>
r9590 <r9590_v>
r9770 <r9770_v>
Number Value
r9780 <r9780_v>
Number Value
p9399[0] <p9399[0]_v>
p9399[1] <p9399[1]_v>
r9670 <r9670_v>
r9672 <r9672_v>
p9799 <p9799_v>
p9729[0] <p9729[0]_v>
p9729[1] <p9729[1]_v>
p9729[2] <p9729[2]_v>
p9899 <p9899_v>
Number Value
p9501 <p9501_v>
p9506 <p9506_v>
p9507 <p9507_v>
p9509 <p9509_v>
p9521 <p9521_v>
p9522 <p9522_v>
p9531[0] <p9531[0]_v>
p9531[1] <p9531[1]_v>
p9531[2] <p9531[2]_v>
p9531[3] <p9531[3]_v>
p9533 <p9533_v>
p9542 <p9542_v>
Function Manual, 04/2014, FW V4.7, A5E34261271B AA