Setting Extended Functions - Siemens SINAMICS G120 Function Manual

5.7

Setting extended functions

STARTER screen form for setting the extended functions
The following STARTER screen form is the starting point for all subsequent settings:
Overview of the procedure
To set all extended functions, proceed as follows:
1. Define the basic settings for all of the safety functions. See Section:
2. If necessary, interconnect the safety inputs and outputs. See sections:
3. If necessary, configure the communication via PROFIsafe. See section: Configuring
4. Adapt the safety functions that you are using to suit your application. See Sections:
5. Complete commissioning. See also Section:
You have set the extended functions.
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 04/2014, FW V4.7, A5E34261271B AA
Basic settings (Page 104).
– Setting safety inputs (Page 111)
– Setting a safety output (Page 120).
PROFIsafe in the converter (Page 127).
– Setting SS1 (Page 130)
– Setting SLS (Page 137)
– Setting SSM (Page 142)
– Setting SDI (Page 146)
Final steps (Page 150).
Commissioning
5.7 Setting extended functions
103