Siemens SINAMICS G120 Function Manual page 75

Procedure
To interconnect the inverter with the motor holding brake via the Safe Brake Relay, proceed
as follows:
1. Connect the Safe Brake Relay to the Power Module using the cable harness provided.
2. Connect the motor holding
You have connected the motor holding brake to the inverter via the Safe Brake Relay.
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 04/2014, FW V4.7, A5E34261271B AA
Power Modules FSA ... FSC:
• Connect the Safe Brake Relay at the
connector on the front of the Power
Module.
• Route the control cable in the guide on
the Power Module.
brake to the terminals of the
Safe Brake Relay:
4.5 Connecting a motor holding brake to a Safe Brake Relay
• Connect the Safe Brake Relay at the
connector on the lower side of the Power
Module.
Power Modules FSD ... FSF
Installing
75