Guide Through The Manual - Siemens SINAMICS G120 Function Manual

Introduction

2.2 Guide through the manual

2.2 Guide through the manual
Chapter
Description (Page 19)
Installing (Page 41)
Commissioning (Page 77)
Operation (Page 159)
Corrective maintenance
(Page 251)
System properties
(Page 267)
Appendix (Page 277)
18
In this chapter, you will find answers to the following questions:
What safety functions does my inverter have?
•
How do the safety functions basically work?
•
What are typical applications for the safety functions of the inverter?
•
In which applications are the safety functions of my inverter not permitted?
•
How many safety inputs and outputs does my inverter have?
•
How do I wire up the safety inputs and outputs of my inverter?
•
What do I have to observe if the wiring extends beyond the control cabinet?
•
How are the PROFIsafe control words and status words assigned?
•
How do I configure the communication of my inverter via PROFIsafe?
•
How do I start commissioning the safety functions?
•
What tool do I need for commissioning?
•
How do I transfer the parameters of the safety functions to other inverters?
•
How do I reset my inverter to the factory setting?
•
How must I select and deselect the safety function?
•
How do the inverter and motor respond when the safety function is active?
•
How do the safety functions mutually influence one another?
•
What happens in the event of a limit violation of the safety functions?
•
What happens in the event of a wire breakage at a safety input?
•
How do I acknowledge safety function faults?
•
How do I replace defective components of the inverter or the inverter itself?
•
How do I ensure that the safety functions are still working correctly after making a
•
replacement?
What do I have to check after making a replacement?
•
What is the meaning of the alarms and faults, which are assigned to the safety
•
functions?
How long does it take for my drive to respond when selecting a safety function?
•
How long does it take for my drive to respond when the safety function is active and the
•
motor malfunctions?
What are the probabilities of failure of the safety functions of my inverter?
•
According to which standards are the safety functions of my inverter certified?
•
How do I check the safety functions after commissioning?
•
How do I document the settings of the safety functions?
•
As machine manufacturer or company operating a machine, what standards and
•
regulations must I observe?
Where can I find more information on my inverter?
•
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 04/2014, FW V4.7, A5E34261271B AA