Guide Through The Manual - Siemens SINAMICS G120C Operating Instructions Manual
Low voltage converters
Hide thumbs
Also See for SINAMICS G120C:
- Operating instructions manual (470 pages) ,
- Compact operating instructions (92 pages) ,
- Getting started (68 pages)
Table of Contents
Advertisement
Introduction
2.2 Guide through the manual
2.2
Guide through the manual
Chapter
Description (Page 27)
Installing (Page 39)
Commissioning (Page 119)
Uploading the converter set‐
tings (Page 165)
Protecting the converter set‐
tings (Page 175)
Advanced commissioning
(Page 183)
Corrective maintenance
(Page 379)
24
In this section you will find answers to the following questions:
•
How is the converter marked?
•
Which components make up the converter?
•
Which optional components are available for the converter?
•
What is the purpose of the optional components?
•
Which motors can be fed from the converter?
•
Which commissioning tools are there?
•
Which sequence is recommended when installing the converter?
•
What does EMC-compliant installation actually mean?
•
Which options are available to install optional components below the converter?
•
What are the converter dimensions?
•
Which mounting and installation materials are required when installing the con‐
verter?
•
To which line supplies can the converter be connected?
•
How is the converter connected to the line supply?
•
How is the braking resistor connected to the converter?
•
Which terminals and fieldbus interfaces does the converter have?
•
What are the interface functions?
•
Which motor data is required for commissioning
•
How is the converter set in the factory?
•
What is the commissioning procedure?
•
How do you restore the converter factory settings?
•
Why is it necessary to back up the converter settings?
•
Which options are available to back up the settings?
•
How does the data backup function?
•
How do you prevent the converter settings from being changed?
•
How do you prevent the converter settings from being read out?
•
How do I protect the converter settings against manipulation?
•
How do I protect my know-how, which is embedded in the converter settings, so that
it cannot be copied by unauthorized persons?
•
Which functions are included in the converter firmware?
•
How are the functions set?
•
What is the meaning of the LEDs provided on the converter?
•
How does the system runtime respond?
•
How does the converter save alarms and faults?
•
What do the converter alarms and faults mean?
•
How are converter faults resolved?
•
Which I&M data is saved in the converter?
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
SINAMICS G120C Converters
Advertisement
Table of Contents
