Chapter 4 Procedures Before Operation - Mitsubishi Electric NZ2GF2BN-60DA4 User Manual

CHAPTER 4
This chapter describes the procedures before operation.
Check box
Setting a station number
Set the station number of the main D/A converter module.
When using an extension module, connect the extension module to
the main D/A converter module.
After that, mount the main D/A converter module on a DIN rail.
Carry out wiring of a power supply, Ethernet cables, and external devices
to the main D/A converter module.
When using an extension module, carry out wiring of a power supply and
external devices to the extension module.
Parameter settings and programming
Set parameters and create a program.
Offset/gain setting
To use user range, configure the offset/gain setting.
*1 To replace the module, refer to the point below.
To replace the module, follow the procedure described below:
• Turn off the module power supply and remove the D/A converter module.
• Prepare a new D/A converter module and follow the illustration above as instructed from "Setting a station
number" to "Parameter settings and programming". (No re-setting of network parameters of the master station is
required.)
• If necessary to use the user range, perform the offset/gain setting.
• Carry out operation check and then restart the control.
PROCEDURES BEFORE OPERATION
Connection
Wiring

CHAPTER 4 PROCEDURES BEFORE OPERATION


Page 49, Section 6.1
Page 50, Section 6.2

Page 52, Section 6.3
Page 57, Section 6.4

Page 59, Section 6.5
Page 62, Section 6.6
Page 68, Section 7.1

Page 75, Section 7.2
Page 136, CHAPTER 9

Page 82, Section 7.3
4
*1
45