How To Change The Parameters; Changing The Network Configuration - Mitsubishi Electric NZ2GF2BN-60DA4 User Manual

7.2

How to Change the Parameters

This section describes the procedures to change the parameters.
The precautions to take when changing the parameters are the same as the following:
• Precautions ( Page 69, Section 7.1 (1))
7.2.1

Changing the network configuration

To change the network configuration reusing the already created project, set the parameters in the following steps:
1.
Turn off the module power supply from on.
2.
Connect the modules again according to the desired network configuration.
3.
Turn on the module power supply from off.
4.
Open the "CC IE Field Configuration" window.
• For the master/local module QJ71GF11-T2
Project window  [Parameter]  [Network Parameter]  [Ethernet/CC IE/MELSECNET] 
• For the master/local module LJ71GF11-T2
Project window  [Parameter]  [Network Parameter]  [Ethernet/CC IE Field] 
5.
Set up the slave station with drag and drop, and enter the station number for the slave station.
Change values as necessary.
button
button
CHAPTER 7 VARIOUS SETTINGS
75
7