Mitsubishi Electric NZ2GF2BN-60DA4 User Manual page 119

(b) When Trigger output request (RY19, RY29) is not assigned to Remote input (RX)
using the external signal assignment function
The following lists the input interval, ON time, and OFF time of Trigger output request (RY19, RY29).
Item
Input interval of the trigger output request
ON time of the trigger output request
OFF time of the trigger output request
*1 SM: Sequence scan time [ms] (User's manual for the CPU module used in the master station)
*2 LS: Link scan time [ms] ( User's manual for the master/local module used)
*3 T is the values shown below.
Extension analog module
Not connected
Connected
Controlled by the D/A converter module
Longer interval than ON time
of Trigger output request
Trigger output request
(RY19, RY29)
OFF
Analog output value of CH1
Analog output value of CH2
Analog output value of CH3
Analog output value of CH4
*1 *2 *3
SM + LS + T
Longer interval than the input interval
of Trigger output request
Longer interval than OFF time
of Trigger output request
ON
OFF
1st D/A conversion value of CH1
1st D/A conversion value of CH2
1st D/A conversion value of CH3
Reference value
[ms]
Value of T
0.2
0.3
Shorter interval than the input interval
of Trigger output request
If the interval from OFF to ON of
Trigger output request is shorter
than the input interval of Trigger
output request, the trigger output
ON ON request is ignored.
OFF
OFF
2nd D/A conversion value of CH1
2nd D/A conversion value of CH2
1st D/A conversion value of CH4
CHAPTER 8 FUNCTIONS
2nd D/A conversion
value of CH3
2nd D/A conversion
value of CH4
117
8