Mitsubishi Electric NZ2GF2BN-60DA4 User Manual page 195

(11)Analog output HOLD/CLEAR setting
For each channel, set whether to hold or clear the analog output value when the CPU module was in the RUN
status, in the event of the STOP status or an error.
b15
Analog output HOLD/CLEAR setting
CLEAR
HOLD
(a) Enabling the setting
Turn on and off Initial data setting request flag (RY9) to enable the setting.
(b) Default value
The default value is CLEAR (0H).
(c) Remote buffer memory address
The remote buffer memory addresses of this area are as follows:
Remote buffer memory name
Analog output HOLD/CLEAR setting
(12)Alert output setting
Set whether to enable or disable alert output for each channel.
b15 b14 b13 b12 b11 b10 b9 b8
0 0
(a) Enabling the setting
Turn on and off Initial data setting request flag (RY9) to enable the setting.
(b) Default value
The default value is Disabled (1) for all channels.
(c) Remote buffer memory address
The remote buffer memory addresses of this area are as follows:
Remote buffer memory name
Alert output setting
to b12 b11 to b8 b7
CH4 CH3
Main D/A converter module
CH1 CH2
0104H
b7 b6 b5 b4 b3
0 0 0 0 0 0
The values of b4 to b15 are fixed to 0.
Main D/A converter module
CH1 CH2
0105H
to b4 b3 to b0
CH2 CH1
0H
1H to FH (a number other than 0)
CH3 CH4 CH1
0204H
b2 b1
0 0 0 0 CH4 CH3 CH2 CH1
0: Enabled
1: Disabled
CH3 CH4 CH1
0205H
APPX
Setting value
Extension D/A converter module
CH2 CH3 CH4
b0
Extension D/A converter module
CH2 CH3 CH4
193
A