4
PROCEDURES BEFORE OPERATION
This chapter shows the startup procedure and program execution of this product.
4.1
Outline
This section explains the procedure outline.
1.
Installing a buttery (FX3U-32BL)
Install a battery in this product. (Page 33 Installing a Battery (FX3U-32BL))
2.
Mounting modules
Mount modules on the base unit, and wire for each device. (MELSEC iQ-R Module Configuration Manual)
3.
Connecting peripheral devices
Connect a monitor, keyboard, and mouse to this product to set up Windows.
For connecting and wiring peripheral devices, refer to the manual of devices to be used.
4.
Setting a date and time
Set a date and time by using the Main menu of BIOS in this product. (Page 92 BIOS Setup)
5.
Setting up Windows
Set up Windows. (Page 34 Setting up Windows)
6.
Wiring and connecting system components
Wire and connect devices to configure the system of this product. (Page 59 SYSTEM CONFIGURATION, Page 71
WIRING)
7.
Setting parameters
Set system parameters, CPU parameters, and module parameters for this product in CW Configurator. (Page 52 Setting
Parameters)
8.
Writing the parameters to this product
Write the set parameters to this product. (Page 54 Writing Parameters to this Product)
9.
Applying the parameters
Reset the bus control of this product to apply the parameters. (Page 54 Applying Parameters)
10.
Checking the operating status
If the ERROR LED of this product is ON or flashing after setting parameters, an error has occurred.
Take a corrective action by following the descriptions for troubleshooting. (Page 220 TROUBLESHOOTING)
11.
Installing or developing applications
Install or develop necessary applications according to the purpose of use.
For the applications that are pre-installed in this product, refer to the following:
Page 62 Applications
To develop an application to run on this product, refer to the following:
Page 56 Creating and registering a user program
4 PROCEDURES BEFORE OPERATION
32
4.1 Outline