Chapter 8 Functions; Mode Shift At Power-On - Mitsubishi Electric NZ2GF2BN-60DA4 User Manual

CHAPTER 8
This chapter describes the details of the functions available in the D/A converter module, and the setting procedures
for those functions.
For details on remote I/O signals, remote registers, and remote buffer memory, refer to the following:
• Details of Remote I/O Signals ( Page 169, Appendix 1)
• Details of Remote Registers ( Page 179, Appendix 2)
• Details of Remote Buffer Memory ( Page 184, Appendix 3)
8.1

Mode Shift at Power-On

At power-on, the D/A converter module enters any of the following modes:
• Offset/gain setting mode
• Unit test mode
• Normal mode
• Trigger output mode
• Synchronous communication mode
The conditions of shift to these modes are shown below:
Offset/gain setting mode
Mark Mode
a) Offset/gain setting mode
b) Unit test mode
c) (Drive mode switch)
84
FUNCTIONS
a)
Power-on
b)
Unit test mode
Normal mode
If x10 of the station number setting switch is set to O/G, the mode shifts to offset/gain setting mode.
For details, refer to the following:
• Offset/Gain Setting ( Page 82, Section 7.3)
If x10 of the station number setting switch is set to TEST and x1 of the switch is set to 0, the mode shifts to the unit
test mode.
For details, refer to the following:
• Unit test ( Page 165, Section 11.5)
With the station number setting switch set to 1 to 120, the module enters each drive mode according to the setting
of Mode switch (address: 0000H).
For details, refer to the following:
• Drive Mode Switch ( Page 85, Section 8.2)
c)
(Drive mode switch)
Trigger output mode
Condition
Synchronous
communication mode