3.5
List of Remote I/O Signals
This section lists I/O signals for a master/local module.
The device number assignment shown assumes that the remote I/O signals of the main module are assigned to RX0
to RX1F and RY0 to RY1F.
Remote input (RX) indicates the input signal from D/A converter module to master/local module.
Remote output (RY) indicates the output signal from master/local module to D/A converter module.
The remote I/O signals of the main D/A converter module and extension module are assigned as shown below.
Module
Main D/A converter module
Extension module
For details on the remote I/O signals, refer to the following:
• Page 169, Appendix 1
Main D/A converter module
Remote input (RX)
RX0 to RX1F
RX20 to RX2F
CHAPTER 3 SPECIFICATIONS
Extension module
Remote output (RY)
RY0 to RY1F
RY20 to RY2F
3
31