Bank Angle Sensor - APRILIA TUONO R FACTORY 2007 Service Station Manual

Electrical system
10.Rear cylinder spark plug
11.Front cylinder injector
12.Rear cylinder injector
Injector
Resistance between 13.8 and 15.2 Ohm.
Power supply 12V
The pulse signal sent by the control unit activates
an electromagnet which attracts an armature that
causes the nozzles set on the injector to open.
Considering the physical properties of the fuel and
the constant pressure of 3.5 bar on the injectors,
the injected volume depends only on the time
these injectors remain open.
Coil
Rear cylinder primary winding resistances be-
tween 0.40 and 1.15 Ohm (to be measured be-
tween pins 9c and 9b).
Front cylinder primary winding resistances be-
tween 0.40 and 1.15 Ohm (to be measured be-
tween pins 9a and 9b).
Secondary winding resistance between 0.40 and
1.15 Ohm (to be measured between pins 9d and
9e).

Bank angle sensor

62 kOhm resistance with sensor at fitting position.
Resistance = Ohm when the sensor is turned 90°
with respect to the fitting position.
ELE SYS - 72
TUONO R_FACTORY